[In case of cooling]
• Start the cooling operation after approx. 1 minute.
[In case of heating (For Heat-pump model only)]
• The heating operation mode is selected in accordance with the room temperature and operation starts after
approximately 3 to 5 minutes.
• After the heating operation has stopped, FAN operation may continue for approx. 30 seconds.
• When the room temperature reaches the set temperature, the super low wind is discharged and the air
volume decreases excessively.
• During defrost operation, the fan stops so that cool air is not discharged. (“
PRE-HEAT” is displayed.)
NOTE
When restarting the operation after stop
• When restarting the operation immediately after stop, the air conditioner does not operate for approx. 3
minutes to protect the machine.
Automatic Operation (Super Heat Recovery Type Only)
When you set the air conditioner in
mode or switch over from AUTO operation because of some settings
change, it will automatically select either cooling, heating, or fan only operation depending on the indoor
temperature.
5-5. Adjustment of Wind Direction
For best cooling and heating performance, adjust the louvers (adjustment of up/down wind direction) appropriately.
CAUTION
• If cooling operation is performed with downward air outlet, dew may fall on surface of the cabinet or the
horizontal louver resulted in dripping.
• If heating operation is performed with horizontal air outlet, unevenness of temperature may increase in the room.
• Do not move the horizontal louver directly with hands; otherwise a trouble is caused.
Select direction of the horizontal louver using
SWING/FIX
switch on the remote controller.
The horizontal louver does not stop immediately even if the switch is pushed.
Adjusting the stop position, push the switch.
22
Содержание MML-AP0074NH-E
Страница 14: ...5 Hz Φ Φ Φ 2 SPECIFICATIONS 2 1 Indoor Unit 13 ...
Страница 15: ...6 Hz Φ Φ Φ 14 ...
Страница 132: ...TOSHIBA CARRIER THAILAND CO LTD ...