Toshiba MML-AP0074NH-E, Руководство по обслуживанию

Страница: 22 / 132

SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
2
3
1
4
HEAT DRY COOL FAN
Heat-pump model
DRY COOL FAN
Cooling only model
(Dehumidify)
HEAT DRY COOL FAN
Heat Recovery model
(Dehumidify)
AUTO
AUTO HIGH MED. LOW
5-4. Correct Usage
• When you use the air conditioner for the first time or when you change the SET DATA value, follow the procedure
below.
From the next time, the operation displayed on the remote controller will start by pushing the
ON / OFF
button only.
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
∗
After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute,
but it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with
ON / OFF
button without turning off the main power switch and
the leak breaker.
• When you use the air conditioner after it has not been used for a long period, turn on the power switch at least
12 hours before starting operation.
Start
1
Push
ON / OFF button.
The operation lamp goes on, and the operation starts.
2
Select an operation mode with the
“MODE
MODE
” button.
One push of the button, and the display changes in
the order shown as follows.
• “ DRY mode” function is not provided to
Concealed Duct High Static Pressure Type.
3
Select air volume with “
FAN
” button.
One push of the button, and the display
changes in the order shown as follows.
• When air volume is “ AUTO”, air volume
differs according to the room temperature.
• In DRY mode, “ AUTO” is displayed
and the air volume is LOW.
• In heating operation, if the room temperature
is not heated sufficiently with VOLUME
“
LOW” operation, select “ MED.” or
“ HIGH” operation.
• The temperature sensor senses temperature
near the air inlet of the indoor unit, which
differs from the room temperature depending
on the installation condition.
A value of setting temperature is the measure
of room temperature. (“
AUTO” is not
selectable in the FAN mode.)
• Air volume of function is not provided to
“Concealed Duct High Static Pressure Type”
but air speed “
HIGH” only is displayed.
4
Determine the set up temperature by
pushing the “TEMP. ” or “TEMP. ”
button.
Stop
Push
ON / OFF
button.
The operation lamp goes off, and the operation stops.
21