TOHATSU TLDI MD 115A SERIES, Руководство по обслуживанию

Страница: 279 / 353

8-12
Electrical System
TLDI 115A 2007
17) Inspection of MAT (Manifold
Temperature) Sensor
1. Measure MAT sensor resistance. Replace if other than
specified value.
MAT (Manifold Temperature) Sensor
Temperature (Reference Value) :
2.35 - 2.55k Ω at 20˚C (68˚F)
0.30 - 0.35k Ω at 80˚C (176˚F)
This test can be made without removing parts.
18) Inspection of MAP Sensor (Manifold
Air Pressure Sensor)
1. Apply 5V between terminals
b
and
c
, and measure
output voltage between terminals
a
and
b
.
Replace MAP sensor if the output voltage is out of
specified range.
c
b
a
（B）
（G）
19) Inspection of Starter Solenoid
1. Connect tester lead wires to both terminal of starter
solenoid.
2. Connector green (G) lead wire to battery positive terminal.
3. Connector black (B) lead wire to battery negative terminal.
4. Check electrical conductivity between terminals of starter
solenoid. Replace if no conductivity.
5. Remove battery terminal from green (G) or black (B) lead
wire, and check there is no conductivity between starter
solenoid terminals. Replace if conductive.
This test can be made without removing parts.
This test can be made without removing parts.
Output Voltage between
a
and
b
: @25˚C
(77˚F) and atmospheric pressure
3.1 - 4.6V
MD115A̲ch08̲E̲2校̲070604.qxd 07.6.6 6:38 PM ページ 12