TOHATSU TLDI MD 115A SERIES, Руководство по обслуживанию

Страница: 206 / 353

6-28
Lower Unit
TLDI 115A 2007
24) Inspection of Drive Shaft
1. Check drive shaft for bend and wear.
Replace if necessary.
2. Measure drive shaft runout.
Runout Limit :
0.3 mm (0.012 in)
25) Assembly of Drive Shaft Parts
1. Attach pinion (B) gear nut
1
to drive shaft temporarily.
2. Install bearing
1
by using press.
Before installing bearing, be sure to clean drive shaft
installation face and apply gear oil.
a
1
2
OIL
GEAR GEAR
GEAR
Bearing Install Tool
2
:
P/N. 3T1-99900-0
CAUTION
Do not press drive shaft thread
a
directly.
Put a piece of protector (steel plate) on the
tip of the shaft.
Refer to "Chapter 6 Shim Adjustment".
3. Install taper roller bearing
3
by using press.
a
OIL
GEAR GEAR
GEAR
3
Bearing Install Tool
2
:
P/N. 3T1-99900-0
CAUTION
Do not press drive shaft thread
a
directly.
Put
a
piece of protector (steel plate) on the
tip of the shaft.
Before installing taper roller bearing, be sure to clean drive
shaft installation face and apply gear oil.
a
a
a
Supporting Points
1
Bearing
Do not reuse.
3 Taper Roller Bearing
Do not reuse.
A nut that fits the thread can be used to protect
the shaft tip when pressing.
MD115A̲ch06̲E̲2校̲070604.qxd 07.6.6 6:34 PM ページ 28