TOHATSU TLDI MD 115A SERIES, Руководство по обслуживанию

Страница: 257 / 353

7-31 TLDI 115A 2007
7
16) Removing Motor
1. Fully extend tilt rod and trim rods.
Blue
Green
CAUTION
Check that tilt rod and trim rods are fully
extended.
D i s a s s e m b l i n g t h e u n i t w i t h t h e r o d s
retracted causes the hydraulic fluid to spurt.
CAUTION
When working on the PTT unit, tilt down
the outboard motor to vertical position.
2. Remove power trim and tilt motor
2
, O ring
3
and gear
pump filter
4
from pump
1
.
2
3
4
1
WARNING
· B e f o r e r e m o v i n g p o w e r t r i m a n d t i l t
motor, fully extent trim rods and tilt arm
to prevent the fluid from spurting due to
internal pressure.
· When removing tilt motor from power trim
and tilt unit, do not push down trim rod or
tilt arm. Doing so causes fluid to spurt.
3. Clean or replace gear pump filter
4
if it is clogged or
damaged.
4. Move lead holder 1 and rubber spacer 2 away from
stator
3
, and remove stator
3
.
3
2
4
1
Cover armature shaft end with clean cloth, hold
the shaft using a pair of pliers, and remove
armature
4
from stator carefully.
5. Remove armature from PTT motor base.
Do not apply grease or oil to commutator.
WARNING
Connecting electrical wires to battery
terminals may cause sparks to occur. Do
not perform this work when flammable
matter is near the working area.
MD115A̲ch07̲E̲2校̲070604.qxd 07.6.7 11:09 AM ページ 31