TOHATSU TLDI MD 115A SERIES, Руководство по обслуживанию

Страница: 25 / 353

1-15
1
TLDI 115A 2007
5. Break-In Operation
Break-in operation is needed for the purpose of
smoothening sliding surfaces between components such
as pistons, piston rings, piston pins, cylinder, and gears.
Method of break-
in operation
Trolling or idling
Throttle Opening: 1/2 of
WOT at approximately
3,000 rpm
Throttle Opening: 3/4 of
WOT at approximately
4,000 rpm
▽ Running at WOT for one
minute every 10 minutes is
acceptable.
▽
Running at WOT for short
period is acceptable.
▽
Run at the lowest speed.
Throttle Opening: 3/4 of
WOT at approximately
4,000 rpm
Regular operation
Time 0 10 minutes 2 hours 3 hours 10 hours
Break-In Operation … 10 Hours
12) Trim Tab
Adjustment of trim tab angle
After installing outboard motor on the boat, use trim tab to
achieve balance between port and starboard steering
loads. Loosen trim tab nut
2
, adjust angle of trim tab 1 as
described below, and then tighten the nut to specified
torque.
1
2
1 1
2 2
3
3 3
å ∫
1 Trim Tab
2 Anti-Ventilation Plate
3 Steering Pivot (Swivel Shaft)
Change trim tab angle a little for each test run
and repeat the process several times until the
best position is found.
Trim Tab Nut
2
：
13 N · m (9 lb · ft) [1.3 kgf · m]
å
If it is necessary to steer to port to make boat run
straight or if boat steers itself to port when steering is
held amidships, move trailing edge of trim tab to port
side, or
∫
If it is necessary to steer to port to make boat run
straight or if boat steers itself to starboard when
steering is held amidships, move trailing edge of trim
tab to starboard side.
Example of Adjustment
2
Trim Tab
Do not reuse.
MD115A̲ch01̲E̲2校̲070529.qxd 07.6.6 5:36 PM ページ 15