TIGIEFFE AIRO A Series, Руководство по эксплуатации и обслуживанию

Страница: 59 / 130

Use and Maintenance Manual – A16 J A18 J Series Page 59
6. HANDLING AND CARRYING
6.1. Handling
Before using the machine, make sure that the mechanical
lock device of the turret is disabled (see figure aside).
To handle the machine in normal operating conditions,
follow the instructions given in chapter "USE
INSTRUCTIONS " under paragraph "Drive and steering”.
When platform is completely lowered (or within a given
height according to specific needs and further to checks)
the machine can be handled (i.e. drive can be performed)
at different speeds to be freely selected by the user.
With platform at a given height, the drive speed is
automatically limited, and cannot be changed.
The section TECHNICAL FEATURES indicates the limits
concerning drive for each model.
Fig.15
WARNING!
Drive with lifted platform may be subject to different restrictions according to the country where the
machine is used. Find out about the legislative limits concerning this operation from the bodies of
Health and Safety at work.
It is absolutely forbidden to drive the machine when platform is lifted unless the ground is horizontal,
flat and steady.
Before carrying out any displacement operation, verify that no people are in proximity of the machine
and in any case proceed with the utmost caution.
Before handling the machine check that the connection plugs are disconnected from the power
supply source.
Check that there are no holes or steps on the floor and bear in mind machine overall dimensions.
Do not use the machine to tow other vehicles.
Before steering and driving the machine, check the actual position of the rotating turret through the
relevant stickers on the chassis to achieve the correct movement direction.
While the machine is being displaced with lifted platform, no horizontal loads can be loaded onto the
platform (operators on board are not allowed to pull wires or ropes, etc.).