TIGIEFFE AIRO A Series, Руководство по эксплуатации и обслуживанию

Страница: 32 / 130

Use and Maintenance Manual – A16 J A18 J Series Page 32
3.3. Use instructions
3.3.1. General
The electric and hydraulic circuits are provided with safety devices, calibrated and sealed by the manufacturer:
DO NOT TAMPER WITH AND MODIFY THE CALIBRATION OF ANY COMPONENT OF THE ELECTRIC AND
HYDRAULIC SYSTEMS.
▪
The machine must be used only in areas well lit up, checking that the ground is flat and firm. The machine may
not be used if the lighting conditions are not sufficient. The machine is not equipped with any lightening
system.
▪
Before using the machine check its integrity and conservation state.
▪ During maintenance operations do not dispose of any waste materials in the environment, but comply with
current regulations.
▪
Do not carry out any service or maintenance operations when the machine is connected to the mains supply.
Follow the instructions given in the following paragraphs.
▪ Do not approach the electric and hydraulic system components with sources of heat or flames.
▪
Do not increase the max. allowed height by means of scaffolds, ladders or other.
▪ With the machine lifted, do not fasten the platform to any structure (beams, pillars or wall).
▪ Do not use the machine as a crane, hoist or lift.
▪
Protect the machine (in particular the platform control panel by means of the specially provided cover- if any -
or a waterproof tarpaulin) and the operator when working in adverse environmental conditions (painting, de-
painting, sand-blasting, washing, etc.).
▪
Using the machine in bad weather conditions is forbidden; in particular, wind speeds must not exceed the limits
indicated in the Technical specifications (to measure speeds, see the following chapters).
▪
Machines with a wind speed limit of 0 m/s are to be used indoors only.
▪
In the event of rain or in parking condition always protect the platform control panel (with the specially provided
cap - if any - or a waterproof tarpaulin).
▪
Do not use the machine in areas where risks of fire or explosion exist.
▪ Do not use pressurized water jets (high-pressure cleaners) to wash the machine.
▪ Overloading the work platform is forbidden.
▪ Avoid knocks and/or contacts with other vehicles and fixed structures.
▪ Leaving or accessing the work platform is forbidden unless this is in the position required for access or leaving
(see the “Accessing the platform” chapter).
3.3.2. Handling
▪
Before handling the machine check that the connection plugs are disconnected from the power supply source.
Always check the cable position during handling if the machine is powered with a 230V electrical pump.
▪
In order to avoid any instability, use the machine on regular and firm grounds. To prevent the machine from
overturning, comply with the max. gradeability values indicated in the Technical data section under paragraph
"Stability limits". However, movements on inclined grounds are to be carried out with the utmost caution.
▪ As soon as the platform is lifted (the tolerance varies from model to model) the safety drive speed is
automatically activated (all models of this handbook have passed the stability Tests in compliance with standard
EN280).
▪
Drive the machine with lifted platform only on flat grounds, verifying the absence of holes or steps on the floor
and bearing in mind the overall dimensions of the machine.
▪ While driving the machine with lifted platform the operators are not allowed to place horizontal loads onto the
platform (operators on board must not pull ropes, wires, etc.).
▪
The machine must not be used directly for road transport. Do not use it for material transport (see paragraph
“Intended use”).
▪
Check that in the operating area there are not obstacles or other dangerous elements.