TIGIEFFE AIRO A Series, Руководство по эксплуатации и обслуживанию

Страница: 51 / 130

Use and Maintenance Manual – A16 J A18 J Series Page 51
5.3. Platform access
The “access position” is the only one from which loading or unloading of persons and materials is allowed. The “access
position” to the work platform is the completely lowered configuration.
To get on the platform:
▪ Get on the platform hanging on to the entry side rails.
▪ Raise the bar and get on board.
Check that, once you are on the platform, the bar falls down
closing the access. Fasten the safety harness to the
provided hooks.
To get on the platform use only the
access equipment the platform is
provided with.
When moving up or down, always keep
your eyes on the machine and hold
onto the entry stringers.
IT IS FORBIDDEN
Lock the closing bar so as to keep the
platform access door open.
Fig. 9
IT IS FORBIDDEN
To leave or access the work platform if it is not in the position required for accessing or leaving.
With the
ground control panel (see paragraph “Ground control panel”) it is possible, operating the boom, to lower the height of
access to the platform for a better access to the platform itself.
5.4. Machine start-up
To start the machine the operator shall:
▪ release the emergency stop button on the ground control panel by rotating it of 1/4 turn clockwise;
▪
turn the on-off key on the ground control panel to "Platform" position
▪
remove the starting key and hand it over to a person in charge on ground, properly informed of the use of the emergency
controls
▪
get onto the platform
▪
Release the emergency stop button on the platform control panel (see previous paragraphs).
For electric-powered machines (models “E”), at this point the various functions can be performed by thoroug hly following the
instructions given in the previous paragraphs. To turn on the machine, the battery charger must be disconnected from the
mains. If the battery charger is working, the machine is off and cannot be turned on.
On Electric/Diesel dual-powered models (models “ED” or “EB”), it is necessary to select the power supply type by means of
the selector. To use the electric drive power once this option has been selected the operator can start performing the various
functions by following the instructions given in the previous paragraphs. To use the thermic drive power read the next
paragraphs to start the heat engine.
For Diesel-powered machines (models “D”):
▪ To use Diesel power select the power type “Diesel” with the selector and then read the next pa ragraphs to start the heat
engine.
▪
To use the 230V or 380V elec tric power (optional) select the power type “Electric” with the selector and then (if available)
the 230V or “380V” voltage (read the next paragraphs to start the three-phase electric motor).