Thermo Scientific SOLA II, Руководство пользователя

Страница: 104 / 205

Maintenance & Troubleshooting
Replacing the Pyrolyzer Heater
10-10 SOLA II User Guide Thermo Fisher Scientific
15. You will need to make a hole in the heater insulation to accommodate the
thermocouple. Insert a drill bit through the fitting in the housing for the
thermocouple and press it through the heater insulation to make the hole.
Remove the bit, and then carefully feed the thermocouple tube through
the stainless steel fitting on the housing (Figure 10-10). Tighten the
thermocouple fitting to secure it to the housing.
Figure 10–10. Insert the thermocouple
16. Slide the two pieces of fiberglass insulation that you removed earlier over
the heater wires, leaving 3/8” exposed (Figure 10-11).
Figure 10–11. Add the fiberglass insulation
17. Insert the ends of the heater wires into the terminal block and tighten
them. Bend the wires as shown in Figure 10-12.