Themis RES-11XR3, Руководство по установке

Страница: 55 / 140

Installation and Operation
Installation Procedures
2-11
Themis Computer
2-9 ). Press down firmly on the clip until it snaps into position.
4. Attach any internal I/O cables to the installed PCI cards, and carefully fold
and tuck any exposed ribbon cables into the cabinet.
5. If you have no further installations to perform, close the RES-11XR3 chassis
by refastening the top cover removed in Step 1 on page 2-11.
6. Attach all external cables to the I/O faceplates of the installed PCI/UIO cards.
Left PCI Riser Card: The left PCI Riser Card accepts a low-profile (half-height),
half-length (6.87”) PCI card. Perform the following steps to install a left-hand PCI
card:
1. If the PCI card being installed has a low-profile rear panel different from that
shown in
Figure 2-10 on page 2-12, it will have to be modified to fit. If no ex-
ternal I/O ports are used, it may be possible to attach the card directly to the
blank rear panel by using the two PCI-card mounting holes.
Blank I/O Panel: If the new PCI card does not have an I/O panel, it can be
attached directly to the blank rear panel (see Figure 2-10 )
Figure 2-9. Installation of the PCI Card Retainer Clip
Install a PCI Retainer Clip on
A
the edge of the Top-Right PCI Card.
Slide the Retainer Clip along the edge of the Top-Right PCI Card until it is over a chassis slot, then press firmly into slot.
B
Caution: Be careful not to install a PCI Retainer Clip into one of the longer chassis
slots used to secure the top cover of the RES-11XR3.