Themis RES-11XR3, Руководство по установке

Страница: 67 / 140

2-23
Themis Computer
Installation and Operation
Operation
2.3.2 Turning the System On
1. Plug the AC power cord from each of the RES-11XR3 power supplies into a
“live” AC outlet.
The LED on each power supply will turn on when AC power is enabled.
2. On the front of the RES-11XR3 push the system power on/off button (see Fig-
ure 2-21 ). This will cause the system
POWER
LED to light (green).
2.3.3 Getting Started
2.3.3.1 Configuration
1. Make sure all SAS/SATA drives are installed (see “SAS/SATA Storage
Drive” on page 2-14). Drive ID numbers are shown in
Figure 2-14 on
page 2-15, Chapter 2. Changes may be made through the BIOS.
2. Make sure that a graphics card is installed in a PCI slot and connect a multi-
scan monitor to the VGA or DVI connector.
3. Attach a PS/2 keyboard and mouse to the appropriate connectors on the rear
I/O panel of the RES-11XR3 (see
Figure 1-5 on page 1-11)
4. Turn the system on (see previous section).
2.3.3.2 Linux Installation
The subject of installing the Linux operating system onto the RES-11XR3 is detailed
in Appendix C, “Red Hat Enterprise Linux 5 Installation”.
Figure 2-21. System Power Button and LED on the RES-11XR3 Front
System Power
On/Off Button
Power LED