Texi XYZ 2518, Руководство пользователя

Страница: 9 / 51

(Note:Part A is connected to the inlet of the vacuum pump and Part B
is connected to the outlet of the vacuum pump)
① Connect No.1 to the air pipe which comes out of the machine.
② Connect No.2 (The signal cable of the returning-air box) to the
“ Returning Air Box ” port on the machine.
③ Connect No.3 to the No.6 by air pipe, and connect the No.7,No.8,No.9
and No.10 of the Part A to the inlet of every vacuum pump.
④ Connect No.4 (Solenoid valve) to the oil water separator (Pneumatic
valve) on the machine by the air tube.
⑤ Connect No.5 to the No.11 by air pipe, and connect the No.12,No.13
and No.14 of the Part B to the outlet of every vacuum pump.
⑥ The No.16 is the pressure relief valve ， the arrow on the pressure
relief must face the Part A, and it to the Part A by the tape firmly.
2.3 Air Compressor
（ Note:1.Air compressor with power over 7.5kW is required for the
Pneumatic oscillating Knife Tool and you need to prepare it by yourself.
2.There is no air compressor for the machine without using it.
）