Texi XYZ 2518, Руководство пользователя

Страница: 32 / 51

All of the above are SP numbers in the panel. Please be sure to
distinguish them from those in the computer software. Please refer to
the actual model. All the SP numbers below are single or double holder
or single holder plus punching tool models.Please consult the
technician for the specific SP numbers of other models.
2. All tools must be taken out of the fixed holders every day before
the machine is shut down, in case that the tools are installed in the
fixed holders for a long time, resulting in rust and unable to be taken
out.
7.1 Oscillating Knife Cutting Tool （ SP4 ， cut,Head1 ）
(1)Grab parts 1 and 2, and then force the cap and the tool bar apart
towards both sides.
(2)The knife must be placed at the bottom of the groove, and the
cutting edge is at the same side with the set screws.
(3)Make sure that the value of the W axis is 0.00 ，
.
(Note:If the coordinate of W axis is not 0.00, you can press the number
of the W, and the coordinate of W axis will automatically change to
0.00. Accordingly, the W axis will also rotate to the origin point
position of the axis)