will pause processing, and the current state will be remembered after
the pause. If the status bar is pressed again, the machine will continue
to work. If you don't want to continue, press the cancel button. If
press the status bar while the graph is not processed, it is equivalent
to pressing the cancel button.
(16)
To control the start and stop of the vacuum pump, press
“
vacuum
”
button before pressing the
“
repeat
”
button. when the
material laid on the working area is firmly absorbed,then press the
“
repeat
”
button to start cutting
(Note: This method is only for the
materials that are not easy to be adsorbed, because after pressing the
“
repeat
”
button, the vacuum pump will work automatically, and then
the machine will start to process the graph.)
(17)
,“
clamp
”
is used to manually control the falling and
lifting of the pressure plate
。“
drag
”
is used to manually send the
material.
(Note:Press the
“
drag
”
button, the pressure plate will fall
automatically, and then the beam will run to the x- direction)
(18)
,
They display the coordinates of the corresponding
axis
,
Z is the height coordinate of the knife tool, W is the rotary
coordinate of the knife tool, A is the rotary coordinate of the punching
tool.
(Note: 1.When install the knife tool, the corresponding W
coordinate must be 0.00, if the W is not 0.00, you can press the
to reset the W to 0.00)
6.3 Adjust Page
(1)Click the
“
adjust
”
page to enter the adjust page.
Содержание XYZ 2518
Страница 1: ...TEXI XYZ 2518 MANUAL...