Texi XYZ 2518, Руководство пользователя

Страница: 42 / 51

(Note:The value of the “ v angle ” must be the same as the angle of the
actual installation position of the knife. ）
C. Press to to return to Vcut page ， when setting the knife depth,
just let the tip of the knife enter the corrugated paper 0.2-0.3mm.
D. Press ， The machine will cut two vertical lines in X direction ，
if it cut like this: or ,press to fine-tune its parameter
till it can cut like this .
E. Press ,The machine will cut two transverse lines in the Y
direction. If the two lines do not coincide,press to
fine-tune its parameter till the two lines coincide.
⑤ Knife depth setting ， drop the tool to the thickness to be cut.
⑥
→ → →
， fine-tune the
data to adjust the over-cutting.
(2)Small knife V-cut tool(SP5 ， Vcut,Head2)
(Note:SP3 must be used during debugging)
① Installation of the knife
② Make sure that the value of the W1 axis is 0.00,and the cutting
edge of the knife must face the X+ direction,tighten the fixing ring
and set screws.