③
Each line of the cross is inclined to the counter-clockwise direction,
then the angle of the tool should be adjusted in the clockwise direction.
(2)Adjust Angle
①
Press
to change the step distance
（
Note:There are five values
for switching:50,10,1,0.1
，
0.03
）
②
For example, if rotate the tool clockwise by 10 degree,the position
of the tool will be corrected,please do it as followings:First
，
press
to change it to
;Second,press
for one
time;Third,after the coordinate of W axis changes by 10 degrees,press
to save the current degree.
(3)Press
to cut the cross again, if the angle of the knife
still is wrong, just need to adjust the angle again till the tool can
cut a cross as shown below:
8.2 Test Offset
(Note:Before testing the offset, the knife depth and the angle must
be set first, and as long as the mark can be cut on the
material.2.Before testing offset, a piece of material should be laid
first, such as corrugated paper, KT board, soft glass, etc.3.The
offset adjustment of all tools is based on the oscillating knife
cutting tool,that is,Head1.)
(1)Press
to change it to
.
(2)Press
,the oscillating knife cutting tool will cut a cross
on the material,and the red dot of the laser lamp will go to the cross
center automatically. If it is not at the cross center, do it as
followings: First,press
to change the step distance which is up
Содержание XYZ 2518
Страница 1: ...TEXI XYZ 2518 MANUAL...
