TELES ECOTEL, Руководство пользователя

Страница: 176 / 247

M O B I L E C O N F I G U R A T I O N O P T I O N S
C H A P T E R 9
176
ECOTEL 3G 16.1. Revised: 2011.
RSSI[<limit>]
Configure this parameter to set a limit for the reception field strength. When the re-
ception field strength falls below this limit, the mobile channel will be blocked. If the
field strength is above the limit, the mobile channel will log on with the mobile car-
rier again. The values used are 0 to 31, which represent the following field
strengths: -113dBm to -51 dBm. An error is generated in the
protocol log
. The
result must be divided by 2.
EXAMPLE: To define a field strength of -95 dBm, subtract -95 from-113 and divide
the result by 2:
- 113dB - (-95dB) = -18dB / 2 = 9
Enter
RSSI[9]
STOP[<val1>,
<val2>]
This entry allows you to define a maximum number of connection setups that always
result in a recorded message (<val1>) without an alert detection or call-connected
signal. The second value (<val2>) counts calls that connect immediately without an
Alert detection. The mobile port is blocked when the defined value is reached and
an entry is recorded in the log file (...Err: Voice). In this way inactive SIM cards that
are forwarded to a recording (with or without a connect from the mobile carrier) can
be recognized and blocked so that they are removed from the routing process. The
default status of this function is off.
VOICE[1]
The B-channel is immediately connected (Siemens dial tone is heard).
NOCP
When this option is configured and the call is from ISDN to mobile, the Call Proceed-
ing signaling message will be eliminated from signaling. This may be necessary if
the ISDN peer does not support Call Proceeding. Bear in mind that the peer’s Setup
Ack Timer is usually set at 5 seconds, which means that an Alert must be generated
as follows:
UMTS=ALERT[5]
FMIN[xxx]
FMAX[yyy]
Sets the frequency range for ringtone recognition (default 400-444 Hz).
EXAMPLE:
UMTS=FMIN[400] FMAX[444]
VOICE[<sec>
] The voice channel in the switching matrix is connected after <sec> (default imme-
diately). The voice channel is activated no later than the point at which the call is
connected.
WND9
Voice recognition is activated in the mobile module if the mobile network signals
WND9 (voice). If this parameter is not set, voice recognition is activated immediately
when the mobile call is initialized.
Module Q24xx only.
WND2A
Generates Alert when WIND:2 is received.
Module Q24xx only.
Table 9.1 Optional Mobile Parameters (continued)
UMTS=...