19
or 150 V)
Note:
The low range provides better resolution and accuracy at
low voltage settings.
4. Set voltage
5. Press On/Off to turn on the channel input. At this time, the actual
input voltage, current, resistance and power will be displayed on
the main interface.
Note:
The load will sink current only if the input voltage is larger than
the conduction voltage of the system (default value is 0 V).
Warning
To avoid electric shock, ensure that the DUT is connected to the
input terminals of the load properly before you turn on the channel
input.
6. Press the Display key to enter the waveform display interface, as
shown in Figure 2-7. By default, the voltage waveform is displayed.
When the input current changes, the load will apply a constant
voltage. Press the Display key again to exit the waveform display
interface and return to the main interface of CV mode.
Figure 2-7 Waveform display interface of CV Mode