Teledyne Sierra M6-2, Руководство пользователя, Страница: 42 / 538

Teledyne LeCroy Performance Analyzer
40 Sierra M6 ‐ 2 SAS/SATA Protocol Analyzer User Manual
In Easy Mode, on the Capture tab, select to capture Everything or Pattern . For Pattern,
select a Pattern. You can exclude patterns and frames. You can use different patterns for
pre
‐ trigger and post ‐ trigger.
In Easy Mode, on the Trigger tab, select the trigger type. For Pattern, select the pattern.
In Easy Mode, on the Initiator Setting or Host Setting tab, select the port and speed.
Select to run the Pattern Generator or Initiator Emulator or Host Emulator.
In Easy Mode, on the Settings tab, select trigger position and memory use. Also change
the Analyzer settings if necessary. Specify addresses, stops, times, and sizes, if necessary.
Use Advanced Mode only after you become familiar with the hardware and software and
have special needs.
1.19 Performance Analyzer
To do a Performance Analysis, select File > New > SAS Performance Analyzer for SAS or
File > New > SATA Performance Analyzer for SATA . Choose settings in the Performance
Analysis dialog. Click Run Hardware (see “Performance Analysis” on page 178 .)
1.20 Target Emulator or Device Emulator
To use the software as a target or device emulator, first select File > New > SAS Target
Emulator or SATA Device Emulator for a new project or File > Open an existing Emulator
file: .std Target Emulator file or .sde Device Emulator file (see “Target and Device
Emulation” on page 184 ). You can also use Project Setup > Last Target Emulator or Last
Device Emulator.
In the Pages tab, change settings for the supported pages if necessary.
In the Error Injection tab, select General periodic errors, Identify frames,
Connection Management open and close connection errors, SAS Commands and events
errors, ATA Commands errors, or SATA Signature content.
Use the User ‐ defined Commands tab only after you have become familiar with
operations.
In the Settings tab, select addresses, sizes, times, and ports, if necessary.
You can capture traffic when using an Analyzer project (but not a Target Emulator
project). With a Protocol Analyzer open, open a
Target Emulator. After checking the
settings, click the Activate/Deactivate (Active) device button. or select Project Setup >
Active Device. If you change Target Emulator settings, Deactivate and then Activate
Device .
1.21 Teledyne LeCroy SAS/SATA Protocol Suite Menu Options and
Toolbars
This section lists all the SAS/SATA Protocol Suite application menu options and the
toolbars.