TeeJet Technologies DYNAJET IC7 140, Руководство пользователя

Страница: 17 / 74

DynaJet® IC7140
www.teejet.com
16
1
2
3
4
5
6
7
8
9
A
CHAPTER 3 - INITIAL START-UP & CALIBRATIONS
The following is the steps required for first-time setup of the DynaJet IC7140 system. When these settings and calibrations are completed, operation
should be possible.
WARNING! With each nozzle change or when nozzles are replaced, a system calibration (steps NO. 5 CALIBRATE THE RATE CONTROLLER
REGULATION and NO. 6 CALIBRATE THE DYNAJET IC7140 SYSTEM) must be completed before attempted operation. These configurations
may affect Gain settings. Failure to properly configure and calibrate the system will result in sub-standard performance. Once complete, operation
may proceed.
NOTE: Information on the ECU will vary depending on the parameters set by the user and the OEM.
NO. 1 POWER UP AND INITIALISATION
Power is continuously supplied to the controller. The universal
terminal (UT) will give access to the controller options and operation.
•
The console needs to be cycled off and back on when
changing or attaching other or additional electronic
components to the system.
Upon startup, the system will cycle the following screens.
►
Initialisation screen – During power-up, the Initialisation screen
is displayed for five (5) seconds, or until all drivers are
scanned.
►
End User Licence Agreement – appears after the Initialisation
screen and will not allow Home Screen access until it has been
acknowledged by pressing the Accept button.
►
Home screen – Once initialisation is complete and the End
User Licence Agreement is acknowledged, the Home screen
will appear. Multiple values are displayed on the Home screen
offering a quick overview of the state of the system
components. When a rate controller is on the system and
communicating, displaying section and boom module interface
information is not required nor displayed.
WARNING! Do not move the machine until the Home screen has
been reached.
Figure 3-1: Power Up and Initialisation Sequence