TEC Electronics Prizrak 5S/BT, Техническое описание

Страница: 6 / 32

6
TEC-67398-2 Technical description Prizrak-5S BT
Slim-tag
Tag – is an electronic key allowing to authenticate an authorized vehicle driver. You must always carry a tag with
you while operating a vehicle. The immobilizer system will automatically detect the tag before the vehicle motion
begins. A confirmatory trill will sound when a tag is detected.
Any modification of Prizrak 5S immobilizer may be upgraded with tags (up to 8 tags in total, including no more
than 4 smartphone tags). The default settings of Prizrak 5S/BT allow to utilize a tag for authentication as soon as
it has been registered without having to change any settings even though tags are not included in the standard
immobilizer set.
• One tag can’t be registered into several immobilizer systems at the same time.
• You may use your smartphone for authentication as well.
Replacing the tag battery
Five short beeps five short beeps following after authentication mean that the battery inside the tag must be
replaced. The battery type is CR-2025. Visit a workshop to have the tag battery replaced by an installer or do it
yourself.
Registering new Slim tags
Register all desired tags within one procedure. The tags that are not taking part in the registration process will
be erased form the immobilizer's memory.
Registration sequence:
1. Select one of the tags that will be used for authentication. Disassemble all the other tags and take the
batteries out of them beforehand. Take the batteries out of each tag in case if a tag is not required for
authentication (e.g. for authentication is used PIN code or PUK code).
2. Carry out an authentication procedure. The immobilizer will emit the confirmatory trill indicating that the
authentication is successful.
3. Press and release the programming button 12 times, the immobilizer will emit 4 short beeps.
4. Press and release the programming button 10 times, the alarm will emit a series of 1 long beeps.
5. Press and hold the brake pedal, the immobilizer will indicate the number of already registered tags by series
of beeps. The number of emitted beeps within one series indicates the total number of registered tags in the
system’s memory.
6. Place a battery into one of the tags. Wait for short intermittent beeps signifying that the tag registration
procedure has started. After a tag has been successfully registered the immobilizer will indicate the total
number of tags programmed into the system’s memory by a series of buzzer beeps. Make sure the number
of emitted beeps matches the number of all tags registered into the system.
7. Insert the battery into the next tag, wait until the tag is registered, repeat the steps described above if more
tags are planned to be registered.
8. Release the brake pedal and turn the vehicle’s ignition OFF after the last tag has been registered, the
confirmatory trill will follow.
• It is allowed to enter the default PIN code «2» with the integrated programming button (reset button) for
authentication if the vehicle hasn’t travelled 10 km after the immobilizer installation and if the default
PIN code hasn’t been already changed.
• It is possible to register up to 8 tags into one immobilizer module.
• A tag will fail to register if the authentication method «PIN code» is set.
Use an edge of
a plastic card
for opening convenience
Use only
unexpired batteries
of high quality!
Open here
Strictly
observe the
polarity
3V
CR 2025