TEC Electronics Prizrak 5S/BT, Техническое описание

Страница: 15 / 32

15
TEC-67398-2 Technical description Prizrak-5S BT
15 «CAN-relay Implant»
diagnostics
—
1 – ready for operation; 2 – not registered; 3 – registration
procedure in progress; 4 – registration failed; 5 – no communi -
cation with CAN-relay; 6 – CAN-relay firmware update required;
7 – Error in connection to CAN-bus
16 Can-relay implant reset to
default values
—
To reset CAN-relay to factory values:
• press the programming button one time;
• wait for the confirmatory trill. The module will inform about the
option status by a series of 2 beeps and LED flashes.
1 — registered; 2 — not registered (reset to default values)
17
A CAN-bus selection via
which is carried out control
over CAN-relay Implant
1
1 — CAN-relay is automatically searched on every available
CAN-bus; 2 — CAN-relay is searched on CAN1; 3 — CAN-relay is
searched on CAN2
Hardware features programming sequence (menu 10)
The entire programming process is carried out through the programming button (hereinafter referred to as —
PB). The immobilizer emits audible indication beeps (hereinafter — beeps) to notify on the current state of a setting
being programmed. In case if the option number or the option value consists of two digits, the sonic indication will
be as follows: the first digit is indicated by long beeps, the second — by short beeps. For example: the figure 12 - will
be indicated by one long beep and two short beeps; 25 — two long and 5 short beeps. It is allowed to enter PIN code
«2» with the programming button if a vehicle hasn't yet travelled 10 km after the installation and the default PIN
code hasn't been changed. The immobilizer will exit the programming mode if at any programming step the ignition
is switched OFF or if within 10 seconds after the last action is made the brake pedal is not pressed.
1. Switch ON the ignition. Carry out an authentication procedure.
2. Enter the programming manu no later than in 10 seconds:
• press and relase the PB 10 times.
• confirmation — 3 beeps. A different number of beeps signifies an error.
3. Select a desirted option within the menu:
• press and release the programming button the number of times necessary to advance from the current
option to a desired one. Each press on the PB encreases the option number by one. The option numbers are
changed in a «circle» - after the last option number goes the first one.
4. To check the curreent status of the selected option:
• press and hold the brake pedal;
• the beeps emitted by the immobilizer will indicate the current value of the option.
5. To change the current value of the option:
• hold down the brake pedal. Each press on the PB will encrease the option number by one. The option
numbers are changed in a «circle» — after the last option number goes the first one.
6. If you need to configure another option within the menu — release the brake pedal — you will go back to the
step №3 of the progrgamming sequence. To quit programming — switch OFF the vehicle’s ignition.