TEC Electronics Prizrak 5S/BT, Техническое описание

Страница: 18 / 32

18
TEC-67398-2 Technical description Prizrak-5S BT
Table 7. The programmable inputs features
The programmable inputs and outputs of the immobilizer system might be configured for different features
from the tables 7 and 8 respectively. Hence, the immobilizer functionality may be easily reconfigured according to
specific needs of an installation technician. Furthermore, the programmable features of the immobilizer may be
assigned to the inputs and outputs of the hood compartment unit HCU-230/BT. However, some of the features can't
be implemented by the HCU-230/BT due to its hardware capabilities.
№ Name of the feature and description
Possibility to
implement
the feature by
HCU-230/BT
1
Brake pedal position monitoring.
Might have to be connected to the brake pedal pin switch output in case if there is no brake
pedal position data running on the vehicle’s CAN-bus (refer to the «Integrator»)
Yes
2
Hood position monitoring.
Is connected to the hood pin switch wire in case if there is no hood position data running
on the vehicle’s CAN-bus
Yes
3
Driver’s door pin-switch input.
Is connected to the driver’s door pin-switch wire if the vehicle’s CAN-bus doesn’t contain
data on the driver’s door status (refer to the «Integrator»)
Yes
4
Hood lock latching via HCU-230.
If a signal is applied to this pulse trigger impulse the immobilizer will send a command to
the HCU-230 to latch an aftermarket electro-mechanical hood lock
Yes
5
Ignition monitoring.
If it is not possible to read the Ignition status data out of the vehicle’s CAN-bus (for exam-
ple, when a vehicle’s specific electrical circuits are being interrupted) then this immobilizer
input must be connected to the vehicle’s wire with co12 volts when the Ignition is
ON. After assigning this feature to any programmable input — the immobilizer stops ana-
lyzing such data on the CAN-bus.
In order to make the immobilizer analyze the ignition status data on the CAN-bus again,
reprogram this input to any other feature or reset the immobilizer to the default settings
Yes
6
Wired button (buttons).
The feature is assigned to a programmable input(s) if it is necessary to connect the im-
mobilizer to the vehicle’s «wired» button(s) which are intended for use as the PIN code
combination buttons in case if the are no «CAN-bus buttons» in a particular car. The pro-
grammable input that was configured as the «Wired button» input must be connected to
the output of a positive or negative button (momentary push-button with NO contacts).
Use the programmable inputs №1 (grey/black) and №7 (grey/yellow) if you need to con -
nect to «resistive» buttons
No
Table 8. Programmable outputs features
№ Name of the feature and description
Possibility to
implement
the feature by
HCU-230/BT
0
The output is not used. It doesn’t generate any signals or pulses Yes
1
«Armed» status.
The output provides a constant level signal after the vehicle is armed by the OEM remote
key (keyless entry system) until it is disarmed
Yes
2
Pulse after «Arming»
The output provides a pulse of 0,8 seconds upon arming the vehicle by the OEM remote
key (keyless entry system)
Yes