TEC Electronics Prizrak 5S/BT, Техническое описание

Страница: 8 / 32

8
TEC-67398-2 Technical description Prizrak-5S BT
PIN code
PIN code is a secret pressings combination on one or more OEM vehicle’s interior buttons. Please refer to the
Integrator files for the list of factory buttons that can be used in a particular vehicle to enter PIN code. PIN code
must be entered every time the ignition is ON or the engine is started prior to driving.
PIN code is a one-, two-, three- or four-digit number. Each digit may consist of figures from 1 to 9.
PIN code may be easily changed as many times as needed either by an installer technician during installation or
by an end alarm user at any convenient time.
In order to ensure the proper secrecy level-the factory-set (default) PIN code must be changed.
If it hasn’t been changed then every time the factory-set PIN code is entered, the immobilizer emits a long
warning beep to remind the alarm user about necessity to change the default PIN code. The default PIN code «2» is
entered with the programming button.
PIN code entry sequence:
1. Switch the ignition ON or start up the engine.
2. Enter PIN code.
3. The confirmatory trill will sound to confirm the PIN code correctness.
The existing PIN code will reset to defaults in case if an existing authentication method is changed for the
authentication method «Tag».
PIN code examples
The buttons , , , , are shown as an example. Consult with your installation technician to find
out the list of available buttons for your vehicle.
Enter PIN code. While entering one of the PIN digits, keep in mind that pressings duration and pauses be -
tween figures within one digit must not exceed 1 second. Pauses between digits have to be approximately 2
seconds.
PIN code entry with one button
One-digit PIN code «2»: Two-digit PIN code «11»:
~1 sec.
~2 sec.
PIN code entry with multiple buttons
Obey the buttons pressing sequence while entering a PIN code.
One-digit PIN code «4»: Two-digit PIN code «22»:
~1 sec .
~1 sec.
~1 sec .
~2 sec . ~1 sec . ~1 sec .
PUK code
PUK code is a 4 digit number located under the protective film of the plastic card that is included in the alarm set.
PUK code entry disables all the anti-theft features of the immobilizer, regardless off what authentication method is
chosen.
It is required to enter PUK code:
• to changed an existing authentication method for a desired one (PUK code required if the vehicle has
already travelled 10 km after installing the Immobilizer system).
• in case if PIN code combination is forgotten and/or a tag is lost or damaged.
PUK code is a 4 digit number located under the protective layer of the plastic card that is included in the alarm
set. A PUK code is entered with a programming button keeping the two (2) second pause between the PUK code
digits.
PUK code entry sequence:
1. Switch ON the ignition or start up the engine;
2. Enter PUK code;
3. Wait for the confirmatory trill;
If you made a mistake while entering the PUK code, take a break for more than 3 seconds and try again.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . .