TEC Electronics Prizrak 5S/BT, Техническое описание

Страница: 17 / 32

17
TEC-67398-2 Technical description Prizrak-5S BT
10 Green/black (8)
wire configuration
Input (-)
or Output (-)
1
1 — Programmable input (-);
2 — Programmable output (-)
11
Green/black (8)
wire function con-
figuration
2
Hood position monitoring.
It’s possible to assign any feature from the table
«Programmable inputs features». If the option
№10 is setup for value «2» — the wire will be
automatically configured for «Vehicle’s CDL
unlocking blockage if a tag is not in range (NC
relay control)» feature (refer to the «Programmable
outputs features», the option №31)
12
White/black wire
(11) function con-
figuration
Output (-) 35
Wired engine locking. May be programmed any
feature from the table «Programmable outputs
features»
Inputs/outputs programming sequence (menu 11)
The entire programming process is carried out through the programming button (hereinafter referred to as -
PB). The immobilizer emits audible signals (hereinafter — beeps) to indicate the current state of a setting being
programmed. In case if the option number or the option value consists of a two-digit number, the beeps will sound
as follows: the first digits are indicated by long beeps, the second digit — by short beeps. For example: the figure
12 — will be indicated by one long beep and two short beeps; 25 — two long and 5 short beeps. It is allowed to en-
ter PIN code «2» with the programming button if a vehicle hasn't yet travelled 10 km after the installation and the
default PIN code hasn't been changed. The immobilizer system will automatically exit the programming mode if at
any programming step the ignition is switched OFF or if within 10 seconds after the last action the brake pedal is
not pressed.
1. Switch the vehicle’s ignition ON. Carry out an authentication procedure.
2. Not later than in 10 seconds enter the programming menu:
• press and release the programming button 11 times.
• confirmation -6 beeps. A different number of beeps signifies an error.
3. Select a desired menu option:
• press and release the programming button the number of times that corresponds to the option number in
the menu. Each time the button is pressed the option number is increased by one. The option numbers are
changed in rotation, after the last option number goes the first one;
4. To find out the current option value:
• press and hold the brake pedal;
• the emitted beeps will indicate the current option value.
5. To change the value of the option:
• keep the brake pedal down. Each time the button is pressed the option number is increased by one. The
option numbers are changed in rotation, after the last option number goes the first one.
6. To configure the value of another option-release the brake pedal. This will bring you back to the step 3 of the
programming sequence. To exit the programming mode — switch the ignition OFF.