TEC Electronics Prizrak 5S/BT, Техническое описание

Страница: 11 / 32

11
TEC-67398-2 Technical description Prizrak-5S BT
Installing the Immobilizer
Micro-USB port
The built-in micro-USB port allows configuring all settings and updating the integrated firmware by connecting
to a PC via a micro-USB cable. All adjustments are made using the interface of a specially designed software
which is called TECprog2. An up-to-date version of the software TECprog2 is available for download at https://
tecel.ru/support/tecprog/
Built-in programming (reset) button:
• This push-button can be used by an installer technician during the installation of the immobilizer. The
button allows:
• to carry out authentication until the vehicle hasn’t yet travelled 10 km after the installation.
• to program the factory vehicle buttons (positive/negative momentary push-buttons).
• to reset the immobilizer to default settings.
Built-in LED light
It reflects some parameters that are obtained from the CAN-bus. Refer to the annex №2 at the end of this manual for
detailed description.
Immobilizer wire harness description
The Immobilizer inputs/outputs assignment is described in the Table 3. Connectors pin numeration is shown in
figure 1. Inputs/outputs adjustment is carried out through the programming menu (see section «Hardware functions
configuration»).
12 7
1 6
Figure 1. Connector pin numeration, view from the wire harness side
Table 3. The immobilizer pin out description
Pin № Wire color
Wire function
Default [optional]
Default value description
1 Grey/black Input (-)
Reference ground of resistive buttons or the input for a
negative button. The input was designed for connection to
the vehicle's buttons that are going to be used for PIN code
combination (PIN
TO
Drive
®
)
2 Pink/green
Input (+)
[Output (+) 150 mA] Brake lights status control
3 Brown
Data bus CAN2
[Output (-) 150 mA] Datra bus CAN2-L
4 Brown Data bus CAN1 Data bus CAN1-L
5 Blue/red
Output (-) 150 mA
[Output (+) 150 mA] Alternative Hazard lights control
6 Black Power source (-)
7 Grey/yellow Input (+) 150мА
A possitive input of resistive buttons or a positive button.
This wire is connected to OEM vehicle's buttons that are
going to be used for PIN code combination (PIN
TO
Drive
®
)
8 Green/black
Input (-)
[Output (-) 150 mA] Hood position monitoring
9 Brown/yellow
Шина CAN2
[Output (-) 150 mA] Data bus CAN2-H
10 Brown/red Шина CAN1 Data bus CAN1-H
11 White/черный Output (-) 150mA Wired engine locking
12 Red Power source (+)