23
TEC-67398-2
Technical description Prizrak-5S BT
Deleting smartphone tags from memory
This procedure may be required to remove previously registered smartphone tags from the immobilizer memory
to prohibit their future use.
It is possible to carry out the procedure in three ways:
1st way.
Install the mobile app Prizrak-ID on a smartphone and pair the smartphone with the immobilizer (refer
to the chapter «Pairing a smartphone with the immobilizer system»). Remove all previously paired smartphones
from the immobilizer memory in the special menu of the app «Registered tags list».
2nd way.
Reset the immobilizer to default settings (refer to the chapter «Resetting to default settings»). After this
hard reset the immobilizer will be able to detect only the tags programmed at the factory.
3rd way.
It may be carried through the programming button. The procedure is the following:
1.
Switch on the vehicle’s ignition. Carry out and authentication procedure.
2.
Not later then in ten seconds enter the programming menu. For this purpose:
•
press and release the programming button 12 times;
•
confirmation - 4 beeps. A different number of beeps signifies that a mistake was made while entering the
code to access the menu.
3.
Select the appropriate option in the menu:
•
press and release the programming button 13 times;
•
the confirmation is 1 long beep and 3 short beeps.
4.
To verify the current value of the option:
•
press and hold the brake pedal down;
•
the number of beeps will indicate the total number of tags registered into system’s memory.
5.
To delete the smartphone tags from memory:
•
still hoding the brake pedal down, press and release the programming button 1 time.
•
the confirmation trill followed after that signifies that the tags have been deleted.
6.
Turn off the ignition to exit the programming menu.
Changing PIN code
1.
Turn ON the vehicle’s ignition.
2.
Complete authentication.
3.
Within 10 seconds after the authentication press and release the programming button 14 times. The
immobilizer will emit one short beep to confirm that the «PIN code change» mode has been successfully
entered.
4.
Set up the new PIN code. Any button of the vehicle that responds by beep when being pressed can be used
to set up the new PIN code combination.
5.
Wait for confirma tion: 1 short beep.
6.
Repeat the new PIN code. Wait for confirmation:
•
two short beeps and the confirmation trill means – the PIN code has been successfully changed, the
immobilizer will automatically exit the programming mode.
•
a long warning beep – PIN code hasn’t been changed due to an error while setting the new PIN code
combination. Repeat the PIN code change procedure starting from the step № 4.
•
It is not possible to set up the new PIN code if the current authentication method is only «Slim-tag».
•
It is not possible to set up PIN code «1» – one press on one button.
Changing
the programming button
Changing the programming button
1.
Reset the module to default settings;
2.
Interface the Immobilizer with a vehicle;
3.
Program the analog buttons if they are planned to be used (the procedure is described above);
4.
Assign any button as the programming button from among the available ones by pressing and holding the
button pressed for longer then 5 seconds until a long beep sounds.
Содержание Prizrak 5S/BT
Страница 1: ...PROTECTION AGAINST PROFESSIONAL CARJACKING IMMOBILIZER TECHNICAL DESCRIPTION...
Страница 32: ...www tecel ru...
