TANDBERG RDX QuikStation, Руководство по эксплуатации продукта

Страница: 51 / 130

O
CTOBER
2011
RDX Q
UIK
S
TATION
41
c. Set the host initiator user name and CHAP password by uncommenting
the following lines and replacing the variables with the actual host
initiator name and password needed to connect to the iSCSI target.
#node.session.auth.username = (host initiator name)
#node.session.auth.password = (CHAP password)
#discovery.sendtargets.auth.username = (host
initiator name)
#discovery.sendtargets.auth.password = (CHAP
password)
d. Restart the iSCSI service by entering the following command:
# /etc/init.d/iscsi start
3. Discover iSCSI Targets.
To discover the RDX QuikStation iSCSI targets, enter the following
command, replacing the variable RDX QuikStation IP address with the actual
IP address for your RDX QuikStation:
# iscsiadm -m discovery -t sendtargets -p
RDX QuikStation
ip address
Depending on how you configured the logical device type for the RDX
QuikStation, you will see two to eight iSCSI targets.
4. Connect iSCSI targets.
To connect all discovered iSCSI targets, enter the following command:
# iscsiadm -m node -L all
To connect to an individual target, enter the following command, replacing
target
IQN
name with the iSCSI qualified name (IQN) of the target and
replacing target portal with the RDX QuikStation IP Address:
# iscsiadm -m node -T
target IQN name
-p
target portal
--login
Once all iSCSI targets are connected, the initiator (Linux host) can use the
iSCSI disks as a normal disk. It appears under /dev/sdx devices and you can
format, mount iSCSI disks like a normal disk.
!
Important
Before you shutdown or restart the RDX QuikStation for any
reason, Tandberg Data recommends that you disconnect all
iSCSI initiators.