TANDBERG RDX QuikStation, Руководство по эксплуатации продукта

Страница: 23 / 130

O
CTOBER
2011
RDX Q
UIK
S
TATION
13
I
NSTALLING THE
RDX Q
UIK
S
TATION IN A
R
ACK
A
SSEMBLING THE
O
UTER
R
AILS
For most standard, 4-post racks, you will need to attach the rail extension
bracket (shown below) to the outer rail instead of the short bracket.
To assemble the outer rails:
1. Measure the inside distance from the front mounting holes to the back
mounting holes on one side of your rack.
2. Fit either the rail extension bracket or the short bracket to the outer rail.
Adjust the bracket to a point where the rail is at the same distance that you
measured in Step 1.
3. Align the bottom and middle hole of a bar nut to the outside of the bracket,
as shown in the above figure. From the inside of the rail, thread two #10
pan-head screws through the rail, bracket and bar nut holes, as shown
above. Do not tighten the screws completely.
4. Repeat these steps for the second outer rail on the other side of the rack.
Figure 2-1 RDX QuikStation outer rack rail assembly
outer rail
rail extension bracket
bar nut