TAMS MasterControl 40-01007, Руководство пользователя

Страница: 51 / 58

MasterControl English
Page 9.1
9. Check list for troubleshooting
9.1. Errors occurring while starting up
After switching on track power, the locomotive responds to switching on / off its functions, but
not to turning the speed control knob.
Possible reason: The driving booster is connected to the breaking booster port, which sends a
„0“ as speed level.
Please connect the booster to the driving booster port.
When switching on the booster by pressing go , your MasterControl switches off and reports
a short circuit.
Possible reason: The short circuit polarity settings of the booster(s) are wrong.
Change the
short circuit polarity settings.
9.2. Errors occurring while setting parameters
The entered parameters are not saved.
Possible reason: You quit the menu point without confirming your input by pressing # / ok.
Repeat the steps and confirm your input by pressing # / ok .
An entered name is not saved.
Possible reason: You entered less than 11 characters.
Repeat your input and if necessary,
enter additional blanks.
When switching on the MasterControl, it blocks when displaying its’ version number.
Possible reason: The locomotive database contains corrupted data, for instance as a result of
cutting power while resetting.
Hold 0 / menu pressed while switching on the
MasterControl, which will then switch to “Delete configuration”. Exec ute this menu point.
When programming a DCC decoder the MasterControl displays an error.
Possible reason: You’ve choosen a programming method not supported by the decoder.
See the manual of the decoder for supported programming methods.
When reading an extended address from the decoder the MasterControl displays an error.
Possible reason: Your decoder does not support extended addresses.
While testing an s88 module, its inputs are displayed as occupied, although most of them / all
of them are idle.
Possible reason: The connector is plugged into the port the wrong way.
Check the
connection.
You cannot test all s88 modules, although their connection is ok.
Possible reason: The setting for the amount of s88 modules is wrong.
Change the setting
for the amount of s88 modules.