TAMS MasterControl 40-01007, Руководство пользователя

Страница: 34 / 58

English MasterControl
Page 6.16
Setting interface baud ra te
Interface baud
2400 Baud
# / ok
Possible actions:
To set the interface baud rate press # / ok.
Navigate to another menu point in submenu level 1 by turning the
speed control knob.
Go back to the main menu by pressing * / esc.
Interface baud
2400 Baud
Possible actions:
Adjust the interface baud rate by turning the speed control knob.
Possible values: 1200, 2400, 4800, 9600, 14400, 19200, 38400,
57600.
Confirm your input by pressing # / ok. You’ll then be taken back
to submenu level 1 and changes are saved.
Cancel with * / esc. You’ll then be taken back to submenu level 1
without saving changes.
Hints:
When using the serial interface, this value has to be set according
to your PC interface configuration.
The USB interface is 57600 and can’t be changed.
Making settings fo r soleno id accesso ry decoders
Points config.
# / ok
Possible actions:
To set the points format press # / ok.
Navigate to another menu point in submenu level 1 by turning the
speed control knob.
Go back to the main menu by pressing * / esc.
S
Setting s tandard da ta format fo r all soleno id accesso ry decoders
All points
Motorola
# / ok
Possible actions:
To set the points format for all solenoid accessory decoders press
# / ok.
Navigate to another menu point in submenu level 1 by turning the
speed control knob.
Go back to the main menu by pressing * / esc.
All points
Motorola
Possible actions:
Adjust the points format for all solenoid accessory decoders by
turning the speed control knob.
Confirm your input by pressing # / ok. You’ll then be taken back
to submenu level 1 and changes are saved.
Cancel with * / esc. You’ll then be taken back to submenu level 1
without saving changes.
Hint:
This setting applies to all connected solenoid accessory decoders.