Tadano GR-130EX, Руководство по обслуживанию

Страница: 57 / 152

Y-7. Y-7.
Assembly Adjustment (Traveling Device)
44
WY05-5160E
6. Torque converter and transmission
6.1 Maximum allowable speed
Units: km/h (mph)
Shift position High position Low position
1 23 (14.3) 16 (9.9)
2 41 (25.5) 23 (14.3)
D 53 (32.9) 41 (25.5)
R 41 (25.5) 16 (9.9)
[NOTICE]
Engine speed: 2700 min
-1
Gauge display
Pay attention to the tachometer and do not overrun
the engine.
(Max. 3000 min
-1
)
Drive-speed selection must be done with the
vehicle at a complete stop and with the brakes not
applied.
The mechanism does not allow 2WD selection in
Low position.
6.2 Adding oil to the torque converter and
transmission
[NOTICE]
When checking the oil level, turn OFF the PTO.
Check at an oil temperature of 50°C (122°F) when
the oil level settles after the engine is started.
Do not add too much or too little oil.
Prevent dust and water from entering when adding oil.
1. With the engine stopped, add oil through the oil filler
port on the top of the torque converter to the
prescribed level on the transmission oil level gauge.
2. Put the transmission in neutral and start the
engine. While idling (770 min
-1
), continue to add
oil. Check that the oil level settles within the range
indicated by the
*
mark on the transmission oil
level gauge.
7. Camera mounting angle adjustment
Adjust the camera mounting angle so that the
mirror in the camera image is located as shown in
the figure below. Then fix the camera.
△
0
345-812-93000
Total oil volume:
approx. 19 L (5 gal)