Svedala-Demag DF 115 C, Руководство по эксплуатации

Страница: 169 / 178

F 31
F
F
_
DF1
15_13
5C_G
B.
fm
. 31-
40 -
02-
01.
03
Outer auger bearing (4.7)
The grease nipples are located on each
side at the top of the outer auger bear-
ings.
These nipples must be lubricated each
time work is finished to force out any bi-
tumen residues that might have entered
and to supply the bearings with a fresh
filling of grease.
Apply 6 strokes of grease using a grease
gun.
When extending the auger, during the initial lubrication of the outer bearing points, the
outer races should be loosened slightly to ensure better aeration when lubricating.
After lubricating, the outer races must be correctly re-secured.
New bearings must be filled with 60 strokes of grease using a grease gun.
Visual inspections (5.1)
- Inspect the diesel engine for oil and fuel patches and fouling.
- Inspect the complete hydraulic system, pumps, motors and cylinders for damage
and leaks.
- Check tension and lubrication of the drive chains.
- Check tension of the track group.
- Check cover and coverings for damage, loose or missing screws.
- Check oil cooler for leaks and fouling.
- Check propane gas system for leaks and hoses for damage. Spray connections
with a foaming agent.
- Check instruments and indicators for damage.
- Check tension of conveyor chains.
- Check augers for smooth operation.
- Check spreader and flight bar conveyor limit switch setting and test for smooth op-
eration.
- Check protective devices such as rail, catwalks, roof braces for completeness.
Crossbeam guide (5.2)
In order to ensure good guidance for the crossbeams, these should be cleaned reg-
ularly.
If necessary, a brush can be used to apply some grease around the guide.
P1250002.jpg