Svedala-Demag DF 115 C, Руководство по эксплуатации, Страница: 111 / 178

D 71
D
D_DF1
1
5_135C_
G
B
.f
m
. 71-
92 -
02-
01.
0
3
Set the switches, levers and controls listed below to the specified positions when the
screed has reached its operating temperature and a sufficient amount of material lies
in front of the screed:
- Push the drive lever (9) all the way to the front and start driving.Screed floating po-
sition is activated now.
- Observe the distribution of the material and adjust the limit switches if necessary.
- Set the compacting elements (tamper and/or vibration) according to the required
compaction ratio.
- Let the paving master check the layer thickness after 5–6 meters and correct if nec-
essary.
Carry out the check in the area of the drive chains or wheels as the screed tends to
level an uneven ground. The reference points for the layer thickness are the drive
chains or wheels.
The basic setting of the screed must be corrected when the actual layer thickness de-
viates significantly from the values indicated by the scales (see the operating instruc-
tions for the screed).
The basic setting is for asphalt material.
Item Switch Position
17 Traction drive fast/slow Tortoise-operating speed
10 Preselector traction drive Mark 6-7
33
Preparation for screed floating posi-
tion
LED ON
23 Vibration LED ON
20
&
Tamper LED ON
24/56 Auger left/right Auto
32/54 Conveyor left/right Auto
51 Levelling Auto
A Speed regulator, vibration ca. mark 40-60
B Speed regulator, tamper ca. mark 40-60