Sun Microsystems Netra 210, Руководство по обслуживанию

Страница: 97 / 122

5-1
C H A P T E R
5
Finishing Up
This chapter discusses tasks performed to finish the service procedures. Topics
include:
■
Section 5.1, “Installing the Top Cover” on page 5-1
■
Section 5.2, “Closing the Bezel” on page 5-3
■
Section 5.3, “Installing the Server Into the Rack” on page 5-4
■
Section 5.4, “Powering On the Server” on page 5-6
■
Section 5.5, “Verifying the Installation” on page 5-7
5.1 Installing the Top Cover
1. Locate where the air duct is to be installed.
Facing the bezel, the air duct is over the center of the system board and covers the
CPUs and memory.
Caution – The server might overheat is the air duct is not installed.
2. Position the air duct over the CPUs and memory, with the rear edge of the duct
under the lip at the chassis rear panel.
3. Lower the air duct so that the handles of the CPU brackets just enter the slots in
the air duct.
See
FIGURE 5-1
.