Sun Microsystems Netra 210, Руководство по обслуживанию

Страница: 47 / 122

Chapter 3 System Board Components 3-7
FIGURE 3-8
Removing the PCI Card From the Slot
7. Determine your next steps:
■
If you were directed here by another procedure, return to that procedure.
■
If you are replacing the PCI card, go to Step 7 of Section 3.3.2, “Installing the PCI
Card” on page 3-7
■
Otherwise, install the air duct and top cover, install the server into the rack,
power on the server, and verify the installation.
■
See Section 5.1, “Installing the Top Cover” on page 5-1 .
■
See Section 5.3, “Installing the Server Into the Rack” on page 5-4 .
■
See Section 5.4, “Powering On the Server” on page 5-6 .
■
See Section 5.5, “Verifying the Installation” on page 5-7 .
3.3.2 Installing the PCI Card
1. Power off the server, remove the server from the rack, and remove the top cover
and airduct.
■
See Section 1.3, “Powering Off the Server” on page 1-3 .
■
See Section 1.4, “Removing the Server From the Rack” on page 1-4 .
■
See Section 1.6, “Removing the Top Cover” on page 1-7 .
2. Locate where the PCI card installs.
The PCI card installs at the left rear of the chassis.
3. Loosen the PCI card thumbscrew at the chassis rear panel.
See
FIGURE 3-9
.