Sun Microsystems 817-4054-15, Руководство по обслуживанию

Страница: 187 / 204

15-1
C H A P T E R
15
Side Handles
This chapter describes how to remove and replace the side handles.
15.1 Replacing the Handles
Caution – This procedure requires the system to be extended out of the system
cabinet on its slides.
1. Take the system to Standby mode.
See Section 4.2, “Taking the System to Standby Mode” on page 4-2 .
2. Make sure that the leveling feet are extended to the floor.
3. Extend and lock the system cabinet stabilizer bar.
See Section 3.1, “Sliding the System Out of the System Cabinet” on page 3-1 and
Section 3.2, “Sliding the System Into the System Cabinet” on page 3-5 .
Caution – Failure to extend and lock the stabilizer bar before you slide a system out
of the rack will cause the system cabinet to tip over.
4. Slide the system out of the system cabinet until the locking latches click.
See Section 3.1, “Sliding the System Out of the System Cabinet” on page 3-1 .
5. Remove the appropriate front bezel door (
FIGURE 15-1
). Release the two hinges on
each section of the bezel by pressing down on the hinge pin levers.
This action releases the hinge pins.