Sun Microsystems 817-4054-15, Руководство по обслуживанию

Страница: 42 / 204

2-6 Sun Fire E2900 System Service Manual • May 2006
2.6 Extending the System Cabinet Stabilizer
Bar
To slide the system out of or into the cabinet and extend the stabilizer bar, see
Section 3.1, “Sliding the System Out of the System Cabinet” on page 3-1 and
Section 3.2, “Sliding the System Into the System Cabinet” on page 3-5 .
2.7 Filler Boards and Filler Panels
Filler boards and panels, which are physically inserted into the board or card slot,
are used for EMI protection and for air flow (
TABLE 2-3
).
2.8 Antistatic Precautions
Caution –
Wear an antistatic wrist strap and use an ESD-protected mat when
handling components. Attach the antistatic wrist strap to the press stud at the rear or
side of the chassis before removing any covers or components.
There are four antistatic strap attachment points on the chassis:
■
Right side towards the front (
FIGURE 2-1
)
■
Left side towards the front
■
Center at the rear
■
Center of the fan tray assembly, at the front
TABLE 2-3
Overheating Precautions Using Filler Boards and Filler Panels
If you remove Do the following
CPU/Memory board Install a filler board in a system to prevent the system from
overheating.
Tape drive or I/O card In order to provide full EMI protection, ensure that filler panels
are installed when removing the tape drive or I/O card.
!