Sun Microsystems 817-4054-15, Руководство по обслуживанию

Страница: 56 / 204

3-8 Sun Fire E2900 System Service Manual • May 2006
d. Raise the handle so that the tops of the front and rear guide posts fit into the
entry holes in the cutouts (
FIGURE 3-5
and
FIGURE 3-6
).
The grooves in the guide posts fit into the narrow slots in the cutouts.
e. Slide the handle and guide posts toward the front of the shipping cradle
(
FIGURE 3-6
).
FIGURE 3-6
Slide Cutouts
Note – Do not tighten the captive screws on the handles. Leave both handles loosely
attached. There must be room between the handles to place the system on the
shipping cradle.
f. Attach the other handle in the same manner. Complete Step a through Step e .
2. Extend the cabinet stabilizer and lock it in position.
3. Disconnect the cables attached to the system.
4. Remove the cable management arm (CMA) from the rear of the system (if
installed).
See Section 5.1.1, “Removing the CMA–Lite” on page 5-2 or Section 5.2, “CMA-800”
on page 5-4 .
5. (Optional) Remove the front bezel doors.
This protects the doors from potential damage during the move.
(Not to scale)
FRONT
Entry hole