Sun Microsystems 817-4054-15, Руководство по обслуживанию

Страница: 90 / 204

6-4 Sun Fire E2900 System Service Manual • May 2006
9. Remove the drive from the drive bay while holding the drive handle (
FIGURE 6-4
).
The hard disk drive rear connector is disconnected when the drive is ejected.
FIGURE 6-4
Removing the Hard Disk Drive
10. Place the drive on an ESD mat.
11. If required, replace the drive as described in Section 6.1.2, “Installing a Hard Disk
Drive” on page 6-4 .
12. Detach the antistatic wrist strap.
13. Close the front door of the system.
14. Reconfigure the disk drive, if necessary, by using DR.
Refer to the system administration manual.
15. Ensure that the OK to remove ( ) LED is no longer lit.
6.1.2 Installing a Hard Disk Drive
1. Open the right front door of the system.
2. Attach a wrist strap. Place a grounded ESD mat close to the system.
See Section 2.8, “Antistatic Precautions” on page 2-6 .
3. Lower the grill in front of the hard disk drives.