Studer SW V4.0 OnAir 1000, Инструкция по эксплуатации и обслуживанию

Страница: 29 / 361

OnAir 1000 Digital Mixing Console
Date printed: 23.10.03 SW V 4.0
General 2-1
2 GENERAL
2.1 Utilization for the Purpose Intended
The OnAir 1000 mixing console is intended for professional use.
It is presumed that the unit is operated only by trained personnel. Servicing
is reserved to skilled technicians.
The electrical connections may be connected only to the voltages and sig-
nals designated in this manual.
2.2 First Steps
2.2.1 Unpacking and Inspection
Your new mixing console is shipped in a special packing that protects the
unit against mechanical shock during transit. Care should be exercised
when unpacking so that the surfaces do not get marred.
Verify that the content of the packing agrees with the items listed on the
enclosed shipping list.
Check the condition of the equipment for signs of shipping damage. If
there should be any complaints you should immediately notify the for-
warding agent and your nearest Studer distributor.
Please retain the original packing material because it offers the best pro-
tection in case your equipment ever needs to be transported.
2.2.2 Installation
Primary Voltage: The power supply unit is auto-ranging; it can be used for mains voltages in
a range of 100 to 240 V
AC
, 50 to 60 Hz.
DC Operation: The console can be operated from a 24 V
DC
source through the respective
24 V
DC
connector provided on the rear panel.
For DC operation it is mandatory that a UL approved, external fuse is
connected in series with one of the supply lines (T 10 A H 250 V UL/CSA).
The power switch next to the power inlet only switches the mains voltage;
for DC operation, an external power switch has to be foreseen by the in-
staller.
Dual (Redundant) Power Supply: For information on the Dual Power Supply versions refer to chapter 14.2 .
General Precautions: Do not use the unit in conditions of excessive heat or cold, near any source
of moisture, in excessively humid environments, or in positions where it is
likely to be subjected to vibration or dust. The ambient temperature range
for normal operation of the unit is +5...+40° C.
Unobstructed air flow is essential for proper operation. The air vents on
the top and bottom of the unit are a functional part of the design and must
not be blocked in any way (e.g. by a manual or a computer screen).
Cleaning: Do not use any liquids to clean the exterior of the unit. A soft, dry cloth or
brush will usually do.
For cleaning the touch-screen display window, most of the commercially
available window or computer/TV screen cleaners are suited.
Use only a
slightly damp (never wet) cloth. Never use any solvent!