Studer SW V4.0 OnAir 1000, Инструкция по эксплуатации и обслуживанию

Страница: 17 / 361

OnAir 1000 Digital Mixing Console
Date printed: 12.07.04 SW V 4.02/V4.03
New Features 3
However, no Monitor Extension module can be installed in an OnAir 1000
console, which means that no other functions (as known from OnAir
2000M2 consoles) can be configured.
4 Additional REC Signaling Output
An additional REC signaling output has been provided on pin 9 of the
SIGN. connector (formerly labeled as “Spare OUT”) to extend the on-air
signaling features.
SIGN. (D-type, 9 pin, male):
Pin Signal Pin Signal
1 +5 V SUPPLY 6 COMMON
2 ON AIR IN – 7 Spare IN – or Ext. CR DIM IN – *
3 CR MIC OUT 8 STUDIO MIC OUT
4 PGM OUT 9 REC OUT
5 GND * depending on Customer Code setting
For the ON AIR INDICATION setting on the COMMON SETTINGS
page, a fourth selection item (
Σ
PROGRAM/
Σ
REC) was created. Depending
on this setting, the two signaling outputs are active according to the follow-
ing table:
SIGN output:
ON AIR
INDICATION
setting
PROGRAM
output on-air
REC
output on-air
Pin 4
(PGM OUT)
Pin 9
(REC OUT)
(new output)
1)
Σ
PROGRAM
AND
Σ
REC
0
1
0
1 0
0
1
1 0
1
1
1 0
1
1
1
2)
Σ
PROGRAM
0
1 x
x 0
1 0
0
3)
Σ
REC
x
x 0
1 0
0 0
1
4)
Σ
PROGRAM
/
Σ
REC
(new setting)
0
1
0
1 0
0
1
1 0
1
0
1 0
0
1
1
In other words:
• For the 1
st
setting, both signaling outputs are active whenever any audio
signal is routed either to the program or the record output (or both).
• For the 2
nd
setting, only the PGM OUT signaling output is active while an
audio signal is routed to the program output. An audio signal routed to the
record output has no effect.
• For the 3
rd
setting, only the REC OUT signaling output is active while an
audio signal is routed to the record output. An audio signal routed to the
program output has no effect.
• For the 4
th
(new) setting, only the PGM OUT signaling output is active
while an audio signal is routed to the program output, and only the REC
OUT signaling output is active while an audio signal is routed to the record
output. If audio signals are routed to both the program and the record out-
puts, both the PGM OUT and REC OUT signaling outputs are active.
Basic information on this subject to be found in chapter 11.2.2
1
2
3
4
5
6
7
8
9