49
Transferring the Initial Configuration to Sensors and Analyzers
Transferring the Initial Configuration to Sensors and
Analyzers
You are now ready to install the StoneGate sensor and analyzer engine(s). The initial
configuration is transferred to the engines during the installation.
What’s Next?
If you have a StoneGate appliance, see the installation and initial configuration
instructions in the
Appliance Installation Guide
that was delivered with the appliance.
After this, return to this guide to set up basic routing and policies (see
Routing and Installing Policies
(page 51) or see the more detailed instructions in the
Online Help
of the Management Client or the
Administrator’s Guide
PDF).
If you are using another type of device as the sensor or analyzer engine, proceed to
Содержание stonegate 5.2
