Stonesoft stonegate 5.2, Руководство по установке

Страница: 36 / 109

36
Chapter 5 Defining Sensors and Analyzers
Defining IP Addresses
 To define an IP address
1. Right-click a physical interface or a VLAN interface and select New → IP Address . The IP
Address Properties dialog opens.
2. Double-click the IPv4 Address cell and enter the IPv4 Address. Repeat for each node if this
is a Sensor Cluster element.
3. Enter the Netmask .
4. If NAT is applied to system communications, double-click the Contact Address cell and
continue as explained in the next illustration. Otherwise, Click OK to close the IP Address
Properties dialog.
 To define a contact address
1. Enter the Default contact address to define the translated IP address of this engine. It is
used by default by components in a different Location.
4 2
3