Sony XDCAM EX PMW-EX3, Руководство по обслуживанию

Страница: 67 / 314

PMW-EX3
2-41
2-2-37. Replacing the Parts in the
Lens Grip
Removing the grip cover
1. Remove the three screws
a
, and remove the
screw
b
. (Fig. 1)
2. While pressing the RELEASE button, press
the T side of the T/W zoom switch, and rotate
the grip cover in the direction of the arrow,
then remove the grip cover. (Fig. 2)
3. Disconnect the harness from the connector of
the T/W zoom switch. (Fig. 3)
Replacing the cap (START/STOP)
1. Remove the cap (START/STOP) by pushing
it in from the outside of the grip cover. (Fig.
5)
2. Install the new cap (START/STOP) by
aligning its notch with the protrusion of the
grip cover. (Fig. 5)
Replacing the rear cover and the grip belt
1. Disengage the two claws from the inside of
the grip cover, and remove the rear cover.
(Fig. 4)
2. Separate the grip belt from the buckle, and
pull it off from the grip cover. (Fig. 6)
3. Install the new grip belt by reversing the
steps of removal. (Fig. 6)
4. Engage the rear cover with the grip cover.
Installing the grip cover
1. Connect the harness to the connector of the
T/W zoom switch. (Fig. 3)
2. Align the hole of the grip cover with the
RELEASE button. While pressing the T side
of the T/W zoom switch, assemble it by
rotating it in the direction opposite to the
arrow. (Fig. 2)
3. Install the three screws
a
, and the screw
b
.
(Fig. 1)
Fig.1
a
a
a
b
Fig.2
T side W side
T/W zoom switch
Grip cover
RELEASE
button
Fig.3
Harness
T/W zoom switch
Fig.4
Rear cover
Claws
Grip cover
(Inside)
Grip cover (inside)
Cap
(START/STOP)
Fig.5
Notch
Protrusion
Fig.6
Grip belt
Buckle
Grip cover