Sony XDCAM EX PMW-EX3, Руководство по обслуживанию

Страница: 35 / 314

PMW-EX3
2-9
2-2-9. Handle Assembly
1. Refer to Section 2-2-5 and remove the
“Handle Top Cover Assembly”.
2. Remove the two screws (B2.6
x
6), and
remove the rear shoe bracket.
3. Disconnect the harness from the connector
(CN1) on the HP-144 board.
4. Remove the connector cover (HP) and the
two screws (M2
x 4), and remove the HP-
144 board.
5 Remove the lens from the main unit.
Lens
HP-144 board
CN1
M2 x 4 (Silver)
B2.6
x
6
(Silver)
Rear shoe bracket
Connector cover (HP)
Main unit
Front cover
handle
Handle assembly
HN-343 board
CN800
Flexible flat cable
Coaxial cable
with connector
DPR-289A board
connector
HN-328 board
CN2
IF-1069 board
CN4
LED-469 board
CN2
M2 x 4
(Black)
B2.6 x 6
(Silver)
B2.6 x 6
(Silver)
6. Disconnect the flexible flat cable from the
connector (CN4) on the IF-1069 board.
7. Disconnect the harness from the connector
(CN2) on the LED-469 board.
8. Remove the two screws (M2 x 4), and
remove the front cover handle.
9. Disconnect the connector (CN2) of the HN-
328 board from the connector (CN800) on the
HN-343 board.
10. Remove the three screws (B2.6 x 6). Lift up
the handle assembly gently and disconnect
the coaxial cable with connector from the
DPR-289A board connector.
n
The handle assembly is connected to the
DPR-289A board by the coaxial cable with
connector.
When disconnecting the coaxial cable with
connector, be very careful not to apply
physical load to the coaxial cable with
connector.