Sony XDCAM EX PMW-EX3, Руководство по обслуживанию

Страница: 45 / 314

PMW-EX3
2-19
2-2-17. SW-1410 Board
1. Refer to Sections from 2-2-1 to 2-2-3, 2-2-5,
2-2-9 and 2-2-13, and disassemble the unit up
to “Inside Panel Assembly” removal.
2. Disconnect the SWC-48 board from the
connector (CN300) on the SW-1410 board.
3. Remove the three screws, and remove the
SW-1410 board.
4. Remove the power switch from the power
switch lever of the SW-1410 board.
5. Remove the power switch slide rail from the
SW-1410 board.
n
Be careful not to drop and lose the power switch.
SW-1410 board
SW-1410 board
Power switch
Power switch lever
Knob of power switch
Power switch slide rail
SWC-48 board
Inside panel assembly
CN300
Tapping
2
x 5
(Black)
S301
S301
6. Reinstall the removed parts by reversing the
steps of removal.
m
.
Check that the knob of the power switch is
normally engaged with the switch (S301)
on the SW-1410 board.
. When reinstalling the removed tapping
screw again, refer to note of section “2-2.
Replacement Procedures.”