Sony HD Super Motion HKCU1001, Руководство по установке

Страница: 21 / 102

. IM/HDCU1000 Series
1-15 (E)
Ref.No. Name Function Factory default setting
S407 TEST
1 Factory use OFF
2 Factory use OFF
3 Factory use OFF
4 Factory use OFF
5 Ethernet
*
Ethernet connection setting ON
ON : Ethernet connection can be set.
OFF : Ethernet connection cannot be set.
6 Factory use OFF
7 Factory use OFF
8 Factory use OFF
S408 MODE2
1 NP-SEL AUTO/N SD-Format setting OFF
ON : Forced into NTSC (525).
OFF : For AUTO, follows the setting of 1.000 (=PAL) /1.001 (=NTSC).
2 Not used
3 GRAY LINE/ON Gray signal output setting OFF
ON : During Gray signal output, when turning CB ON/OFF, the Gray image
disappears, leaving only the Line signal.
OFF : During Gray signal output, even when turning CB ON/OFF,
the Gray signal is output.
4 MONI/SYNC For switching signals between the CHARACTER/SYNC output in HDCU1500 OFF
ON: Outputs SYNC. (Switch between HD and SD with S412)
OFF: Outputs a character monitor signal.
5 CAM PWR ON: Creates a backup when the CAMERA POWER ON/OFF is operated OFF
BACKUP * 1 from a remote control panel.
OFF: Starts at CAMERA POWER ON.
6 Not used _
7 Not used
_
8 CO-AX DIS/ENB Factory use OFF
S409 CCU-NO CCU No. setting _
1 to 4 S409-4 to 1: 1’ digit (BCD) OFF (ALL)
5 to 8 S409-8 to 5: 10’ digit (BCD) OFF (ALL)
S410 HD-SD DLY Video phase setting between HD and SD LINE-DLY
Sets the phase difference (delay time) between HD signal and SD signal
output from CCU.
Can switch the delay settings among 0-DLY, LINE-DLY, and FRAME-DLY.
0-DLY : Same-phase mode of HD-SD (excluding 24PsF)
LINE-DLY :
Sets the minimum delay amount of D/C. SD signal delays as
much as 90H (1080i) or 120H (720P).
FRAME-DLY : Sets the frame delay amount. SD signal delays as much as
1 frame (1080i) or 2 frames (720P).
* 90H is the level frequency of 1125-60i/50i, and 120H is that of 720-60P/50P.
n
If the format setting of the camera is set to 24PsF when the 0-DLY mode is set,
the setting is treated as Frame-DLY.
The phase difference between the HD-60 signal that underwent 2-3 Pull-Down
and the SD signal that underwent D/C from that is 1 frame (2 frames for 720P).
S411 SEQ1&SEQ2 Switch depending on the waveform monitor to be used. ( + )
+ : PNP : PNP open collector output
_ : NPN : NPN open collector output
* : This function has been added to software V1.10 and the later versions.
* 1 : This function has been added to software V1.20 and the later versions.