Smith & Nephew LENS Integrated System, Руководство по эксплуатации и обслуживанию

Страница: 9 / 48

9
10601034 Rev. B
LENS Integrated System Operations/Service Manual
System Controls
Rear Panel Overview
Figure 2 . LENS Integrated System Camera Control Unit Rear Panel (REF 72204354 - Wi-Fi enabled, REF 72204685 - no Wi-Fi)
Rear Panel Connections Function
1. HD-DVI Output A high-definition digital visual interface (1080p) output for DVI-compatible HD digital displays. The DVI-I
connector supports DVI-D (DVI-Digital) single-link interfaces. The DVI connector also supports 1080i. To
configure the connector, select the Advanced Settings icon from the SYSTEM CONFIGURATION MENU screen.
2. HD-SDI Outputs Two Serial digital interfaces with component digital video output for HD-SDI-compatible video displays or
video transmission equipment. The HD-SDI connectors support 1080i. To configure the connector, select the
Advanced Settings icon from the SYSTEM CONFIGURATION MENU screen.
3. S-Video Output An analog serial digital interface output for legacy NTSC S-video compatible video displays and accessories.
The S-Video output does not support PAL.
4. Peripheral Controls (2) Two standard 1/8” mini phono plug (3.5 mm) peripheral cable connectors allow control of peripheral devices
such as printers and image capture devices from the camera head.
5. Fuse Holder The clip holds a dual fuse. See the “Technical Specifications” section of this manual.
6. AC Mains Power The switch applys power to the control unit. The switch can be set to off ( O ) or on ( I ).
7. Power Cord Connector Accommodates the hospital grade power cord accessory. This receptacle is an integral part of the power input
module.
8. Equipotential Compensator Terminal
(case ground)
Brings other equipment to the same case potential as the device
9. Wi-Fi antenna connector Accommodates the removable antenna for communication with supported Wi-Fi devices
10. USB Recepticle Supports USB storage devices or keyboards
11. Composite Input Standard composite video (CV) provides a video input for the supported composite output devices (C-arms,
operating room cameras, etc.). This input supports NTSC or PAL, but it must be configured for the desired input.
Refer to the “Advanced Settings” section of this manual for information about how to configure the composite
input but must be configured from the Advanced Settings screen to match the input to be used.
12. Ethernet port For service use only.
13. Exhaust port for power supply Exhaust port for venting of air through the system. To avoid the risk of the System overheating, do not block,